| | |  | Drawplates | Home » » » » Drawplate Wire Metal Drawing Round Tool 63 Hole Steel | | | | | | | Description: | | 63 Round Hole Drawplate For Shaping Wire. This is a new 63 round hole drawplate. The holes are round, in proper increments, so that wire drawn from a preceding hole will go through the next hole easily. The hole sizes are 0.013 mm to 1.5 mm. It measures approximately 4 1/2" (114 mm) long. | | | Product Details: | | | Average Customer Rating:
|  based on 2 reviews |
| | | | Customer Reviews: | |
Average Customer Review:
 ( 2 customer reviews )
Write an online review and share your thoughts with other customers.
Most Helpful Customer Reviews
1 of 1 found the following review helpful:
 Cool tool but entirely too small for Viking knitting!Aug 28, 2010
By Duane A. Barrett
"MsDee"
I was so excited to start my foray into Viking knitting that I didn't bother to verify the actual size of this thing. The package came much faster than I anticipated and I'm thankful but the drawplate is entirely too small. It's just a little bit wider than an emory board and probably half as long. It's made of sturdy steel but the holes range from a small pinhead to a miniscule one. The image shown is definitely enlarged to show details. There is no way to get the wire through the first hole so forget about the 63rd! Unfortunately I have to send it back.
 UselessMar 20, 2012
By Ruzica
This drawplate is almost useless, there is a wide range of same holes, they are set in order without any logic, three same holes, than one bigger than first one, than range of tiny holes, then another big one and so on...
Holes are not smooth, some of them have defects so when you pull out the wire, wire is not round any more.
Have to buy another one.
| | |
|
