150 New Jewelers Tools For Making Wire And Repairing Jewelry. Melting Dish. This is a new melting dish. This ladle is used for melting metals for casting jewelry and other items. The tool has a wooden handle for insulation, and has a cast iron bowl dipped in nickel. The bowl has a 5 mm pouring spout. The bowl diameter is approximately 2" (51 mm) and the handle is approximately 6" (152 mm). Double Sided Mold. This is a new double sided ingot mold. This steel mold is used to convert scrap into suitable shape for rolling sheet or drawing wire. The metal is melted in a crucible and poured into the mold. Features two narrow lines and one wide line. Measurements (approximate). Wide Line: 6 1/2" x 3/4" x 5/16" (165 x 19 x 7.9 mm). Narrow Lines (each): 6 1/2" x 5/16" x 3/8" (165 x 7.9 x 9.5 mm). Handle: 3" (76 mm). Overall: 11" x 1 3/16" x 1" (280 x 30 x 25 mm) 3 Draw Plates This is a new set of 3 jeweler's draw plates. With these drawplates you can reduce and shape thickness of gold, silver, platinum, brass, copper or soft steel wire. The holes are progressively smaller, in proper increments, so that wire drawn from a preceding hole will go through the next hole easily. Occasional annealing will keep wire soft, and bee's wax can be used as a lubricant. These are of economical quality, which offers great versatility. You receive: One 25 half round hole 6" (152.4 mm) long drawplate with hole sizes 5 x 2 mm to 3 x 1 mm. One 63 round hole 4 1/2" (114.3 mm) long drawplate with hole sizes 1.5 mm to 0.013 mm. One 25 square hole 6" (152.4 mm) long drawplate with hole sizes 3.3 mm to 1.2 mm. Fixed Jeweler's Saw Frame. This is a new fixed saw frame. This deluxe saw frame features rigid construction and fine balance for the serious craftsman. It is made of the finest materials. If you haven't found the right saw frame then this is the one for you. This is not too heavy not too light just right to make sawing easy. Measurements (approximate): Throat Depth: 4".